Genie gict390-3bl 3-button remote control manual
Refer to Door and Door Opener Owners Manuals before attempting any repairs.
2013 GMI Holdings, Inc. .Note: It is possible to press the remote historia alegre de portugal pdf button too quickly or lightly.To check that the Genie G3T-BX Remote control button has been programmed correctly, press the button on the remote again; the door should operate. Wall Console must be mounted in sight of door, at least 5 feet above fl oor and clear of moving door parts.Reprogram the Opener with the remaining Remote(s) (Repeat Section 2 for each remote).Press both and simultaneously on the powerhead and hold for 5 seconds.Progr, aM, sET, pR ogram SET 5 secs progr AM SET 5 secs progr AM SET progr AM SET press and hold until you SEE both Blue LEDs come ON SEE long Purple LED come steady ON release SEE round Blue LED come ON Programming is complete. .Lights go out and, round blue light comes.Press and release the button on the remote you want to program; the LED indicator will flash or glow steadily (varies by model).How do I program a Genie remote?Note: For openers manufactured between, use the two upper buttons on the remote ctions are for openers with the type keypad shown below.For additional information or help contact Customer Service: GMI Holdings Inc. .Links in the description are typically affiliate links that let you help support the channel at no extra cost.Press the same remote button again; the LED indicator will go out.The door automatically stops at the end of the open or close cycle.Reprogram the Opener with the remaining Remotes following the programming instructions for that powerhead.Match battery polarity with symbols inside battery housing.And remember to clear all people, pets, ladders, vehicles and other obstructions from the garage doors path before activating (see our Safety Center for more information.).Press remote and release (the button you want to program.) press and release SEE long Purple LED fl ashing SEE both LEDs fl ash Blue and go OFF press and release remote button again 6 press and release remote button a third time 1 program THE opener 3 Button Remote operating instructions program SET program SET.Genie gict390-3BL 3 button remote intellicode.Reprogram the Opener with a remote or any other access device using the instructions accompanying those devices.